Set the number of
To set or change the number of
1.On the control panel, press Setup.
2.Use the arrow buttons to select Fax setup, and then press OK.
3.Use the arrow buttons to select Fax Recv. setup, and then press OK.
4.Use the arrow buttons to select Rings to answer, and then press OK.
5.Use the alphanumeric buttons to enter the number of
Set the answer mode
Depending on the situation, set the product answer mode to Automatic or Manual. The
●Automatic: In this answer mode, the product answers incoming calls after a specified number of rings or upon recognition of special fax tones. To specify the number of rings, see Set the number of
●Manual: In this answer mode, the product never answers calls. You must start the
To set or change the answer mode, complete the following steps:
1.On the control panel, press Setup.
2.Use the arrow buttons to select Fax setup, and then press OK.
3.Use the arrow buttons to select Fax Recv. setup, and then press OK.
4.Press OK to select Answer mode.
5.Use the arrow buttons to select the answer mode, and then press OK. The
Set fax forwarding
You can set your product to forward incoming faxes to another fax number. When the fax arrives at your product, it is stored in the memory. The product then dials the fax number that you have specified and sends the fax. If the product cannot forward a fax because of an error (for example, the number is busy) and repeated redial attempts are unsuccessful, your product prints the fax.
If the product runs out of memory while receiving a fax, it terminates the incoming fax and only forwards the pages and partial pages that have been stored in the memory.
When it is using the
1.On the control panel, press Setup.
2.Use the arrow buttons to select Fax setup, and then press OK.
3.Use the arrow buttons to select Fax Recv. setup, and then press OK.
ENWW | Change fax settings 91 |