Item | Values | Explanation |
|
|
|
SHOW ADDRESS=OFF | AUTO | Sets whether or not the MFP IP address will be shown with |
| OFF | the Ready message. If this value is “on” the address of the |
|
| EIO card in slot 1 is shown. |
|
|
|
TRAY BEHAVIOR | USE REQUESTED | Specifies the behavior of the tray by indicating which tray the |
| TRAY | MFP should print from. |
| MANUAL FEED | USE REQUESTED TRAY sets the tray that the MFP should print |
| PROMPT | from for specified jobs. The values for this menu item are |
| PS DEFER | EXCLUSIVELY (default) or FIRST. |
| MEDIA | MANUAL FEED PROMPT determines whether or not the MFP |
|
| prompts the user when a job does not match a requested |
|
| configured tray. The values for this menu item are ALWAYS |
|
| (default) or UNLESS LOADED. |
|
| PS DEFER MEDIA sets whether the |
|
| based on PostScript rules or HP rules. The values for this |
|
| menu item are ENABLED (default) or DISABLED. |
|
|
|
SLEEP DELAY=90 | 1 | MINUTE |
MINUTES | 15 MINUTES | |
| 30 MINUTES | |
| 60 MINUTES | |
| 90 MINUTES | |
| 2 | HOURS |
| 4 | HOURS |
Sets how long the MFP remains idle before it enters Sleep mode:
●Minimizes the amount of power consumed by the MFP when it is idle.
●Reduces wear on the MFP electronic components (turns off the display backlight).
●When you send a print job, press a control panel key, open a paper tray, or open the top cover, the MFP automatically exits Sleep mode.
|
| Note |
|
| Sleep turns off the backlight on the display, but the display is |
|
| still readable. |
|
|
|
WAKE TIME | SETTING WAKE | Sets the time that the MFP automatically comes out of Sleep |
SUBMENU | TIME | mode. This feature can be set for a different time for each |
|
| day of the week. |
|
|
|
PERSONALITY=AUTO AUTO PCL PS PDF XHTML MIME
Select the default product language (personality). Possible values are determined by which valid languages are installed in the MFP.
Normally you should not change the product language (the default is AUTO). If you change it to a specific product language, the MFP does not automatically switch from one language to another unless specific software commands are sent to the MFP.
CLEARABLE | ON | Set the amount of time that a clearable warning appears on |
WARNINGS=JOB | JOB | the printer control panel. |
|
| ON: Warning messages appear on the control panel until they |
|
| are cleared. |
|
| JOB: Warning messages appear on the control panel until the |
|
| end of the job from which they were generated. |
ENWW | Configure device menu 205 |