3Loosen the two captive thumb screws on the back of the MFP.

4Grasp the screws and pull the formatter board out of the MFP. Place it on a flat, non-conductive surface.

5Remove the DIMM from the antistatic package. Hold the DIMM with fingers against the side edges and thumbs against the back edge. Align the notches on the DIMM with the DIMM slot. (Check that the locks on each side of the DIMM slot are open, or outward.)

Note

See Installing memory for the maximum amount of memory for each DIMM slot.

ENWW

Installing memory 215