10-2

CMS-6R4 Series - User’s Guide
10.2. Command Summary
Function
Command Syntax
Command Availability
Supervisor Non-Super.
Initiate Boot Cycle /BOOT[,Y] <n> [Enter]
/BO[,Y] <n> [Enter]
XX
Connect /C <n> [n] [Enter] XX
Copy RS232 Port Parameters /CP <n> [Enter] X
Third Party Disconnect/D[,Y] <n> [n] [Enter]
/D[,Y] * [Enter]
X
Set Plugs to Default State /DPL[,Y] [Enter] X
Erase Buffer /E[,Y] <n> [n] [Enter]
/E[,Y] * [Enter]
X
Set System Parameters /F [Enter] X
Set to Factory Defaults /FD[,Y] [Enter]X
Help Menu /H [Enter] XX
Reset Network Interface /I [Enter] X
Display Site ID /J [Enter] X X
Set Network Port Parameters /N [Enter] X
Turn Off Plug n/OFF[,Y] <n> [Enter]
/OF[,Y] <n> [Enter]
XX
Turn On Plug n/ON[,Y] <n> [Enter]XX
Set RS232 Port Parameters /P <n> [Enter] X
Set Plug Parameters /PL <n> [Enter] X
Display Main Status Screen /S [Enter] XX
Display Port Diagnostics /SD [Enter] XX
Display Network Status /SN [Enter] X
Telnet Connection Out /TELNET <ip>[port][raw] [Enter] X
Send Parameters to a File /U [Enter] X X
Upgrade Firmware /UF [Enter] X
Unlock Invalid Access Lockout /UL [Enter] X
View Password Directory /V [Enter] X
Display Port Parameters (Who) /W [n] [Enter] XX
Exit Command Mode /X[,Y] [Enter]X X
Resident Disconnect^X X X
The ",Y" argument can be included to suppress the command confirmation prompt.
Command only applies to the ports and plugs that are allowed by the password/account.
Non-Supervisors are not allowed to create third party connections, or connect to ports that are
not allowed by their password/account.
Third Party Disconnect: Disconnects two or more nonresident ports. Must be issued from a
third port with Supervisor command capability.
The Non-Supervisor Mode Help Menu will not include commands that are only available to
Supervisors.
Non-Supervisors can only apply this command to their resident port.
Resident Disconnect: Disconnects your resident port from another port. The disconnect
sequence can be redefined via the Port Configuration Menus.