Operation

CMS-6R4

v1.00

Site ID: (undefined)

 

Display

Display Help Screen

Configuration

 

/H

/F

 

System Parameters

 

/S

Display Status

/PL [n]

Plug Parameters

 

/SN

Display Network Status

/P [n]

 

Port Parameters

 

/SD

Port Diagnostics

/N

 

Network Parameters

 

/W [n]

Port Parameters (Who)

/CP <z>

Copy Serial Port Parameters

/V

View Password Directory

/U

 

Send Parameters to File

 

/J

Display Site ID

/UF

 

Upgrade Firmware

 

Control

 

/FD

 

Factory default the unit

 

Set Plugs to Default State

+------------------------------------

 

+

/DPL

optional name or number

/BOOT <n>

Boot Plug n

[n]

/ON <n>

Turn On Plug n

<m>

=

required name or number

/OFF <n>

Turn Off Plug n

<n>

=

required name(s) or

/C <m> [n]

Connect - Local [remote]

=

required number(s) or

/D <n>

Disconnect

=

* for “all”

/E <n>

Erase Buffer

n:n

=

plug n through plug n

/UL

Unlock Invalid Access

n+n

or n n = plug n and plug n

/I

Reset Network Interface

,y

=

bypass “Sure? (y/n)”

/X

Exit/Disconnect

z

n,n-n,... *

/TELNET <ip> [port] [RAW] Telnet Out

+------------------------------------

 

+

CMS>

Figure 6.2: The Text Interface Help Screen (Supervisor Mode Shown)

6.2. Operation via the Text Interface

When using the Text Interface, all switching and port connection functions are initiated by invoking simple, ASCII commands. ASCII commands are also used to display status screens and to log out of command mode. The Text Interface includes a Help Menu, which summarizes all available CMS-6R4 commands. To display the Text Interface Help Menu (Figure 6.2), type /H and press [Enter].

Notes:

Wait for the "CMS>" prompt to appear before entering commands. The prompt will not reappear until the previous command is complete.

Commands are not case sensitive. All commands are invoked by pressing [Enter].

You are only allowed to issue commands to the outlets and ports that are allowed by the password entered during login.

If command confirmation is enabled, the CMS-6R4 will display the Status Screen after commands are successfully completed.

When switching and reboot operations are initiated, Boot/Sequence Delay times will be applied as described in Section 5.5.5.1.

If the password entered at login does not permit Supervisor Level commands, then the Help Screen will only list Non-Supervisor commands.

6-3

Page 67
Image 67
I-Tech Company CMS 6R4 Series manual Operation via the Text Interface, Dpl