5-32
CMS-6R4 Series - User’s Guide
• Supervisor Mode: Permits or denies access to Supervisor Mode at this
port. When Supervisor Mode is enabled, and a password that permits
Supervisor level commands is entered at this port, the port will allow
access to Supervisor Mode. When this feature is disabled, the port
will not allow access to Supervisor Mode, even when a password that
normally permits Supervisor Mode is entered at this port.
(Default = Permit.)
Note: Supervisor Mode cannot be disabled at Port 1 (the System
Setup Port.)
• Logoff Character: Defines the Logoff Character for this port. The
Logoff Character determines the command(s) or character(s) that must
be issued at this port in order to disconnect from a second port. (Resident
Disconnect.) (Default = ^X ([Ctrl] plus [X]).)
• Sequence Disconnect: Enables/Disables and configures the Resident
Disconnect command. This prompt offers the option to either disable the
Sequence Disconnect, or select a one character format or a three character
format. (Default = One Character).
Notes:
• When a Resident Connection is initiated, the CMS-6R4 will send
a message which lists the connected ports, and displays the one
character or three character command that will be required in order
to disconnect.
• The One Character Disconnect sequence is intended for situations
where the destination port will not receive the disconnect command.
When the Three Character format is selected, the disconnect
sequence will pass through to the destination port prior to breaking
the connection.
• When the One Character format is selected, resident connections are
terminated by entering the selected Logoff Character only. There is
no need to press [Enter] before and after the Logoff Character when
the One Character format is selected.
• When the Three Character format is selected, the Resident
Disconnect Sequence will use the format "[Enter]LLL[Enter]",
where L is the selected Logoff Character.