Step 1540-21
1.Insert the diagnostic
2.Turn off the power.
3.Connect one of the external devices that was disconnected from a PCI adapter in “Step
Note: If the device has a power switch, ensure that the device is turned on.
4.Turn on the power.
5. When the keyboard indicator is displayed (the word keyboard on an ASCII terminal or the keyboard and hand icon on a graphical display), press the F5 key on the directly attached keyboard or the number 5 key on an ASCII terminal
6.If the Console Selection screen is displayed, choose the system console.
7.Enter the appropriate password if you are prompted to do so.
Is the "Please define the System Console" screen displayed?
NO Either the last external device that you connected, the adapter, or system board is probably defective.
To test each FRU, exchange the FRUs in the following order:
1.If the failure is related to an external device that you are responsible for servicing, then follow the service procedures for that device. Otherwise, contact the vendor (or have the customer contact the vendor) to have the device serviced.
2.System board (see note 3 on page
| Repeat this step until all the listed devices are connected. |
YES | Repeat this step until all the listed devices are connected. |
| Go to “Step |
Step 1540-22
Consult the PCI adapter configuration documentation for your operating system to verify that all installed adapters are configured correctly.
Go to "MAP 0410: Repair Checkout " in theDiagnostics Information for Multiple Bus Systems.
If the symptom did not change and all the FRUs have been exchanged, call your service support person for assistance.
