IBM DS6000 Series manual Adding volumes to iSeries using iSeries Navigator

		Specify ASPs to Add Units to
Specify the ASP to add each			unit to.
Specify	Serial				Resource
ASP	Number	Type	Model	Capacity	Name
	21-662C5	4326	050	35165	DD124
	21-54782	4326	050	35165	DD136
1	75-1118707	1750	A85	35165	DMP135
F3=Exit	F5=Refresh		F11=Display disk		configuration capacity
F12=Cancel
Figure B-25 Adding multipath volumes to an ASP

Note: For multipath volumes, only one path is shown. In order to see the additional paths, see “Managing multipath volumes using iSeries Navigator” on page 349.

5.You will then be presented with a confirmation screen as shown in Figure B-26.Check the configuration details and if correct, press Enter to accept.

Confirm Add Units

Add will take several minutes for each unit. The system will have the displayed protection after the unit(s) are added.

Press Enter	to confirm your choice for Add units.
Press F9=Capacity Information			to display the resulting			capacity.
Press F12=Cancel to return and change your choice.
	Serial			Resource
ASP Unit	Number	Type Model		Name	Protection
1					Unprotected
1	02-89058	6717	074	DD004	Device	Parity
2	68-0CA4E32	6717	074	DD003	Device	Parity
3	68-0C9F8CA	6717	074	DD002	Device	Parity
4	68-0CA5D96	6717	074	DD001	Device	Parity
5	75-1118707	1750	A85	DMP135	Unprotected
F9=Resulting Capacity			F12=Cancel

Figure B-26 Confirm Add Units

Adding volumes to iSeries using iSeries Navigator

The iSeries Navigator GUI can be used to add volumes to the System, User or Independent ASPs. In this example, we are adding a multipath logical volume to a private (non-switchable) IASP. The same principles apply when adding multipath volumes to the System or User ASPs.

Follow the steps outlined in “Adding volumes to an Independent Auxiliary Storage Pool” on page 334.

346DS6000 Series: Concepts and Architecture