Croma24 Service Manual

Failure to use an approved anti-static bag for storage or shipment may cause damage to the Carrier PCB and affect the Warranty.

6.Place the Carrier PCB in an ESD bag (anti-static bag) in preparation for shipment to ENCAD for replacement or repair, or if it is to be stored at your facility for repair.

Install the Carrier PCB

1.Put the tab on the left end of the Carrier PCB into the slot in the left side of the Carrier Assembly. See Figure 5-7.

2.Ensure that no flex cables are underneath the Carrier PCB.

3.Push down the right end of the Carrier PCB until the latch snaps into place.

4.Reattach all flex cables on the Carrier PCB. Ensure that the ferrite remains on the black cartridge flex cable.

5.Perform the Carrier Assembly, Carrier Belt, and the Frame Tensioner Reinstallation procedures to reinstall the Carrier Assembly.

Remove the Paper Sensor or the Encoder Sensor

1.Perform the Carrier Assembly, Carrier Belt, and the Frame Tensioner Removal procedures to remove the Carrier Assembly from the Slide Shaft.

102 Assembly\Disassembly

Page 102
Image 102
Integra CROMA24 service manual Install the Carrier PCB, Remove the Paper Sensor or the Encoder Sensor