Integra CROMA24 service manual Stepper Motor Removal/Installation

Croma24 Service Manual

7.Remove the C-Bracket Assembly by removing the four attaching screws. See Figure 5-14.

8.Using a #2 Phillips screwdriver, remove the grounding strap on the left side of the Slide Shaft.

9.Remove the Slide Shaft using a 3mm hex head driver.

10.Disconnect the Lower Drive Shaft Assembly from the Platen by removing the 4 attaching screws. See Figure 5-14.

11.Remove the Platen by releasing the 4 securing tabs (2 on each side) and six screws. Gently lift the Platen off of the Base.

12.Disconnect the Stepper Motor cable from J7 on the MPCB.

13.Disconnect the Stepper Motor ground strap from the MPCB.

14.Raise the Lower Drive Shaft Assembly out of the Base.

Figure 5-15. Stepper Motor Removal/Installation.

15.Remove the Stepper Motor Extension Spring from the Stepper Motor and the post on the Left Lower Drive Shaft Bracket. See Figure 5-15.

16.Remove the hardware securing the Stepper Motor to the Left Lower Drive Shaft Bracket and remove the Stepper Motor.

114 Assembly\Disassembly