Integra CROMA24 service manual Assembly\Disassembly

Croma24 Service Manual

Failure to use an approved anti-static bag for storage or shipment may cause damage to the MPCB and af- fect the Warranty.

14.Place the Carrier Assembly in an ESD (anti-static) bag in preparation for shipment to ENCAD for replacement or repair, or if it is to be stored for repair at your facility.

Install the Carrier Assembly, Carrier Belt, and the Frame Tensioner

1.To install the Belt onto the Carrier Assembly, the “bumps” on the belt (where the ends of the belt are joined together to make the belt continuous) must be positioned between the left and right posts of the Belt Clamp. See Figure 5-5.

2.Slide the Carrier Belt between the right post and the middle post and guide it down into the Belt Clamp. Then slide the Carrier Belt between the left post and the middle post and finish placing the Carrier Belt into the Belt Clamp.

3.Check the position of the Carrier Belt to make sure it matches Figure 5-5.

4.Make sure the left end of the Trailing Cable extends out beyond the left end of the Trailing Cable Support Assembly.

5.Slide the Carrier Assembly onto the left end of the Slide Shaft, making sure that the Encoder Strip fits into the slot in the Slider and the Encoder on the Carrier PCB. Guide the belt while sliding the Carrier Assembly from left to right on the Slide Shaft.

6.Move the Carrier Assembly to the left end of the Slide Shaft and align the left bushing on the Carrier Assembly with the left end of the Slide Shaft.

98 Assembly\Disassembly