Integra CROMA24 service manual Install the Trailing Cable Cover Assembly

Croma24 Service Manual

8.Using a #2 Phillips screwdriver, remove the three screws and washers securing the Trailing Cable Cover Assembly to the C- Bracket Assembly. See Figure 5-10.

9.With the Carrier Assembly in the far right position (if still installed), carefully slide the Trailing Cable Cover left until it clears the back of the Carrier Assembly. Then lift the Trailing Cable Assembly out of the printer.

Install the Trailing Cable Cover Assembly

1.Ensure that the Carrier Assembly (if installed) is at the far right side of the Slide Shaft, position the Trailing Cable Support Assembly in front of the C-Bracket and offset to the left enough to clear the Carrier Assembly.

2.Carefully slide the right side of the Trailing Cable Cover Assembly behind the Carrier Assembly until the screw holes on the Trailing Cable Cover Assembly lines up with the holes in the C-Bracket Assembly.

3.Fasten the Trailing Cable Cover Assembly onto the C-Bracket Assembly with 3 screws with 15 in-lb of torque.

4.Insert the right side of the Trailing Cable through the hole provided in the Platen and Secure to the J6 connector on the MPCB.

5.If the Carrier Assembly is not installed, perform steps 5 through 18 of the Reinstalling the Carrier Assembly, Carrier Belt, and the Frame Tensioner procedures.

6.Push the Trailing Cable up through the opening in the Strain Relief.

7.Fold the Trailing Cable and press it down onto the tape.

8.Slide the fold in the Trailing Cable under the triangular portion of the Strain Relief.

9.Slide the Ferrite Bracket onto the Strain Relief until the catch is securely in place on the Strain Relief.

DISASSEMBLY ASSEMBLY/

Assembly\Disassembly 107