Croma24 Service Manual
the Encoder clear the ridges which hold it in place. Then pull it straight out. See Figure
Install the Paper Sensor or the Encoder Sensor
Figure 5-9. Paper and Encoder Sensor Installation.
1.To install the Paper Sensor:
a.Turn the Carrier Assembly so that the bottom side of it is facing up.
b.Route the flex on the Paper Sensor through the slot in the Carrier Assembly. Make sure the flex cable goes all the way through and does not curl under the Carrier PCB.
c.Grasp the Paper Sensor between thumb and index finger
and guide the sides of the board into the grooves on each side of the opening. See Figure
d.Push the Paper Sensor board down into the Carrier Assembly until it snaps firmly into place.
