Remove Servo Motor, Frame Tensioner | Integra CROMA24 specification

Croma24 Service Manual

6.Connect the Servo Motor connector to J4 on the MPCB.

7.Connect the Power Supply connector to J5 on the MPCB.

8.Connect the Stepper Motor connector to J7 on the MPCB.

9.Connect the Fan connector to J3 on the MPCB.

10.Connect and lock the Trailing Cable connector to J6 on the MPCB.

11.Reinstall the Middle and Right Covers by performing steps 2 through 4 of the Reinstall the Left, Middle, and Right Covers procedure.

Remove Servo Motor

1.Perform the Left, Middle, and Right Cover Removal procedures to remove the Left, Middle and Right Covers.

2.Disconnect the Servo Motor connector (red and blue wires) at the J4 location on the MPCB.

3.Depress the back of the Frame Tensioner (see Figure 5-2) to create slack in the Carrier Belt and slip it off of the Servo Motor pulley.