Croma24 Service Manual
Always turn the printer OFF, remove the power cord and the interface cable before beginning any disasembly procedures. An electrical shock hazard may be present if these precautions are not followed.
Remove the Left, Middle (Lid), and Right Covers
Removing the Left Cover allows immediate access to the left side of the Platen for removal of the Carrier Assembly, Carrier Drive Belt, Tension Assembly, and the Cutter Activator.
Removing the Right Cover provides immediate access to the Main Printed Circuit Board (MPCB), Control Panel, Servo Motor, and the MPCB connections (to the Stepper and Servo Motors, Fan, Trailing Cable, and Power Supply.)
The Middle Cover (Lid) needs to be removed before any of the other covers can be removed. It also gives access to the Carrier Assembly and the Service Station when in the open position.
1.Remove Cover Retaining Clips (2) from the Middle (Lid) Cover. Insert a Needle Nose Pliers into the square openings near the back of the Lid and remove the Retaining Clip.
2.Put the Middle Cover (Lid) in the open position by lifting the front of the Middle Cover to the full upward position.
3.Remove the Middle Cover by pushing the Middle Cover backwards to disengage it from the Left Cover pin. Push back on the right side to disengage it from the Right Cover pin.
4.Remove the Right Cover by using a flat head screwdriver to unhook the locking clasps located in Figure
