Croma24 Service Manual

3.Place the test cartridge upright on a flat surface and ‘zero’ the gauge by loosening the knob near the top and turning the dial until the needle is at the ‘0’ position on the dial. Tighten the knob. See Figure 3-18.

Figure 3-18. Zeroing the Micrometer Gauge.

4.Remove the Cyan ink cartridge. Snap the test cartridge with the micrometer gauge into the position vacated by the Cyan ink cartridge. See Figure 3-19. Ensure that the micrometer can be read from the BACK of the printer.

Figure 3-19. Test Cartridge Installed.

5.Remove the trailing cable assembly.

6.Loosen the three screws located on the back of the C-bracket that secures the stabilizer to the C-bracket.

62 Maintenance

Page 62
Image 62
Integra CROMA24 service manual Zeroing the Micrometer Gauge