Croma24 Service Manual
4.Move the Carrier Belt to the left so it is out of the way of the Servo Motor pulley.
5.Move the Carrier Assembly to the left end of the Slide Shaft.
Integrated circuits may become weakened or dam- aged by electrical discharge. Do not touch or work near integrated circuits without wearing an ESD wrist strap.
6.Put on an ESD wrist strap.
7.In order to have access to the back screw on the Servo Motor, it is necessary to disconnect the Trailing Cable from the MPCB and lift up the right end of the Trailing Cable. Disconnect the Trailing Cable connector at the J6 location on the MPCB.
8.Lift up gently and hold the right end of the Trailing Cable.
9.Using a #2 Phillips screwdriver, remove the back screw on the Servo Motor. The screwdriver will be at a slight angle. Be careful not to strip the head of the screw or to cause damage to the Encoder Strip.
10.Lower the Trailing Cable back into place.
11.While holding the Servo Motor, remove the front screw on the Servo Motor.
12.Tilt the bottom of the Servo Motor towards the back of the Platen and carefully lower the motor through the opening and out of the back of the printer.
DISASSEMBLY | ASSEMBLY/ |
|
|
