Croma24 Service Manual
Install the Power Supply and AC Entry Module
1.Insert the AC Entry Module by snapping it into the Power Supply base.
2.Install Power Supply board into the Power Supply base using four mounting screws and washers. Attach the ground wire from the AC Entry Module to the lower Power Supply cover mounting screw.
3.Connect the AC Entry Module plug into TB1 on the Power Supply board.
4.Attach the Power Supply cable to the TB2 connector on the Power Supply board.
5.Place the Power Supply cover over the assembly and slide into place over the loosened screws on the Power Supply base. Ensure that the grounding strap is still attached to the screw on the Power Supply base.
6.Insert the Power Supply Assembly into the printers Base. Orient the assembly so that the extensions on the back of the Power Supply base slip into the square holes in the Base of the printer and that the AC Entry Module extends through the back of the printer.
7.Apply pressure downward on the Power Supply Assembly until it snaps firmly into place.
8.Connect the ground lug to the grounding stud on the Base. See Figure
9.Position the Power Supply cable into the cable supports inside the front part of the Base until it reaches the MPCB.
10.Connect the Power Supply cable to the J5 connector on the MPCB.
11.Carefully secure the Platen onto the printer Base. Ensure that the ground straps for the Slide Shaft and
