Intermec SR60 manual To set the beeper options

Chapter 5 — Configuring General Features

Note: For the loudest beep signal, set the beeper volume to 3 and the good read beep frequency to high.

•The Good Read Beep Frequency bar codes on page 136 adjust the pitch of the beeper to low, medium, or high.

•The Good Read Beep Duration bar codes on page 137 can be adjusted to short (100 msec), medium (250 msec), or long (500 msec).

•The When to Beep bar codes on page 137 let you configure the scanner to emit the good read beep when one of these events completes:

•Decode of a bar code label.

•Transmission of data from the scanner to the host.

•(RS-232 interface only) CTS activation at the host terminal.

For more details about the beeper, see “About the Scanner LEDs and Beeper” on page 6.

To set the beeper options

1Scan the SET bar code.

2Scan the bar code(s) for the options. you want to configure.

3Scan the END bar code.

SET -------------------------------------------

Beep Signal

Beep Off---------

SR60 Scanner Programmer’s Reference Manual 135