
Chapter 3 — Configuring Label Transmit Settings
MSI/Plessey---------
END ------------------------------------------
Setting a Single-Character Label ID
The scanner does not transmit a label ID character if its hex value is set to zero. If you need a Label ID that contains only a single character, you can set a
To set a single-character label ID
1Using the ASCII chart on page 158, identify the ASCII character and the corresponding hex code for the single- character label ID.
For example, suppose you want to change the Label ID for
2Scan the SET bar code on page on page 58.
3Using the bar codes in “Selecting the Symbology” on page 58, scan the bar code representing the symbology whose Label ID you want to change.
For this example, you would scan the
4Using the list of bar codes that starts on page 154, scan the two digits corresponding to the hex value you chose in Step 1.
5Scan the 0 digit twice to disable transmission of a second character.
For this example, you would scan 3, 8, 0, and 0.
Note: Successful programming requires four digits for the label ID.
62 | SR60 Scanner Programmer’s Reference Manual |