Chapter 1 — Introduction to Programming the SR60 Scanner
Scanner LEDs
The amber Laser On LED is located on top rear of the scanner and lights whenever laser power is on.
The green Good Read LED is located on top rear of the scanner and flashes:
•once to indicate when a good read has occurred.
•slowly on and off to indicate the scanner is in Programming mode.
Scanner Beeper
The beeper operates differently when the scanner is in Scanning mode and in Programming mode.
•When the scanner is in Scanning mode, the beeper sounds:
•four times at
•once following a good read.
•six rapid chirps to indicate an error (error tone).
•When the scanner is in Programming mode, the beeper sounds:
•once when entering or exiting Programming mode.
•three times to indicate a successfully programmed feature.
•an error tone if you scan programming bar codes for features that are not compatible with the current interface. For example, you can set baud rate and parity only when the current interface is
Integrating the Scanner With Your Host System
Your scanner must be equipped with the correct hardware to properly communicate with your host system. Contact your local Intermec representative if you have questions about your scanner hardware compatibility.
Intermec offers the following interface cables for the SR60 scanner:
•Wand emulation
•
SR60 Scanner Programmer’s Reference Manual | 7 |