Chapter 1 — Introduction to Programming the SR60 Scanner

Restoring Factory Default Settings

You can restore the factory default settings at any time by scanning the Return to Factory Default Settings bar code in this section. This bar code is typically used to return the scanner to a known operating state when the present programming status is not known, faulty, or suspect.

For a list of factory default settings, see Appendix A, “Factory

Default Configuration” on page 145.

Use this bar code with caution, since it resets all changes made during previous programming sessions.

Note: This bar code does not reset the Low Power mode. For details, see “Configuring the Low Power Mode” on page 140.

To restore factory defaults

1Scan the SET bar code.

2Scan the Return to Factory Setting bar code.

3Scan the END bar code.

SET -------------------------------------------

Return to Factory Default

Settings---------

END ------------------------------------------

10

SR60 Scanner Programmer’s Reference Manual

Page 22
Image 22
Intermec SR60 manual Restoring Factory Default Settings, To restore factory defaults