Intermec SR60 Wand Emulation Pre/Post-Noise Settings, To set pre-noise or post-noise transitions

Chapter 2 — Configuring Interface Settings

Wand Emulation Pre/Post-Noise Settings

You can independently configure the number of noise transitions generated prior to or following label transitions.

To disable transmitting pre-noise or post-noise transitions

1Scan the SET bar code.

2Scan either the Don’t Transmit Pre-Noise bar code on page 17 or the Don’t Transmit Post-Noise bar code on page 18.

3Scan the END bar code. You have disabled noise transitions.

To set pre-noise or post-noise transitions

1Scan the SET bar code.

2Scan either the Set Pre-Noise Transitions bar code on page 17 or the Set Post-Noise Transitions bar code on page 18.

3From the “Keypad Bar Codes” on page 154, scan two digits that represent the appropriate number of noise transitions. You can choose from one to twenty noise transitions for either pre-noise or post-noise. For example, scan the 0 and the 3 bar codes for three transitions.

4Scan the END bar code.

Pre-Noise Transitions Settings

SET -------------------------------------------

Don’t Transmit Pre-Noise ---------

Set Pre-Noise Transitions ---------

SR60 Scanner Programmer’s Reference Manual 17