Intermec SR60 manual Setting Global Prefixes, To set global prefixes

Chapter 3 — Configuring Label Transmit Settings

Note: In the Global Prefix and the Global Suffix columns, 00 indicates no character.

Setting Global Prefix(es)

You may add one or two prefix characters to the standard label format. To add more than two prefix characters, contact Intermec Product Support for Full Label Edit (FLE) options.

To set global prefixes

1Identify your specific system requirements.

2Using the ASCII chart on page 158, identify the ASCII character(s) and the corresponding hex code(s) for the prefix.

For example, suppose you want to send the two prefix characters STX (start transmit) and SP (Space). The ASCII chart shows that STX equals 02 hex and SP equals 20 hex.

3Scan the SET bar code on page 50.

4Scan the Set Prefix bar code.

5Using the list of bar codes that starts on page 154, scan the four digits corresponding to the hex values you chose in Step 2.

For this example, you would scan 0, 2, 2, and 0.

Note: Successful programming requires four digits for the label ID.

Note: If you make a mistake or lose your place while setting this option, scan the END bar code to exit Programming mode. The scanner sounds a two-beep error tone to indicate that programming was incomplete, and the setting remains as it was before entering Programming mode.

6Scan the END bar code.

SR60 Scanner Programmer’s Reference Manual 49