Intermec SR60 Reconfiguring the Interface Settings, Removing and Replacing an Interface Cable

Chapter 1 — Introduction to Programming the SR60 Scanner

3Holding the scanner handle and end cap together in one hand, pull the connector out of the handle end cap to free the interface cable.

4Connect the new interface cable at the scanner and rotate the forked cable retainer to secure it. Tighten the screw to 0.67 to 1.13 Nm (6 to 10 in-lb).

1

3 2

Removing and Replacing an Interface Cable

Reconfiguring the Interface Settings

If you change the interface cable, you may need to reconfigure the interface settings. For help, see Chapter 2, “Configuring Interface Settings.”

After you reconfigure the interface settings, you should scan a bar code to verify that the scanner communicates correctly with the new host system. For sample bar codes, see “Sample Bar Codes” on page 152.

SR60 Scanner Programmer’s Reference Manual 9