Intermec SR60 Changing the Interface Cable, Verifying that Your Scanner Supports the Interface

Chapter 1 — Introduction to Programming the SR60 Scanner

•Keyboard wedge

•USB

Note: The part numbers for the keyboard wedge cables available from Intermec are listed in the “PC Keyboard Interfaces and Cables Supported ” table on page 31.

Changing the Interface Cable

If you need to move the scanner to a host terminal of a different interface type, you simply connect the scanner to the new host using the appropriate interface cable. The scanner automatically changes to the interface functions specific to that cable.

Verifying that Your Scanner Supports the Interface

You must make sure that your SR60 scanner supports the interface you want to change to. The following list indicates the interfaces each SR60 scanner supports:

•SR60 scanner with C/N SR60AX01 supports the Wand Emulation, RS-232, and Keyboard Wedge interfaces.

•SR60 scanner with C/N SR60AX02 supports the USB interface.

You can find the scanner C/N on the label above the trigger.

Removing and Replacing the Scanner Interface Cable

You can change your scanner interface cable by following these instructions.

To change the scanner interface cable

1Loosen the screw at the bottom of the handle. This screw is captive and does not come all the way out.

Do not try to pull the end cap off, as this may damage the scanner.

2Swing the forked cable retainer clear of the square hole in the end cap and rotate away from the cable.

8 SR60 Scanner Programmer’s Reference Manual