Lexmark MS510DN, 35ST301, 35S0450, MS610 Too many flash options installed, Too many trays attached

Troubleshooting 204

Too many flash options installed [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra flash memory.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Too many trays attached [58]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the extra trays.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Unformatted flash detected [53]

Try one or more of the following:

•From the printer control, select Continue to stop the defragmentation and continue printing. For non‑touch‑screen

printer models, press to confirm.

•Format the flash memory.

Note: If the error message remains, then the flash memory may be defective and need to be replaced.

Unsupported option in slot [x] [55]

1Turn off the printer.

2Unplug the power cord from the electrical outlet.

3Remove the unsupported option card from the printer controller board, and then replace it with a supported card.

4Connect the power cord to a properly grounded electrical outlet.

5Turn the printer back on.

Weblink server not set up. Contact system administrator.

Select Continue to clear the message. For non‑touch‑screen printer models, press to confirm.

Note: If the message appears again, then contact your system support person.