Lexmark MS610DN, 35ST301, 35S0450 Using MS610de 106, Settings General Settings Timeouts Sleep Mode

Using MS610de 106

Adjusting Sleep mode

To save energy, decrease the number of minutes the printer waits before it enters Sleep mode. Select from 1 to 120. The factory default setting is 30 minutes.

Note: The printer still accepts print jobs when in Sleep mode.

Using the Embedded Web Server

1Open a Web browser, and then type the printer IP address in the address field.

Notes:

•View the printer IP address on the printer home screen. The IP address appears as four sets of numbers separated by periods, such as 123.123.123.123.

•If you are using a proxy server, then temporarily disable it to load the Web page correctly.

2Click Settings > General Settings > Timeouts.

3In the Sleep Mode field, enter the number of minutes you want for the printer to wait before it enters Sleep mode.

4Click Submit.

Using the printer control panel

1From the home screen, navigate to:

> Settings > General Settings > Timeouts > Sleep Mode

2In the Sleep Mode field, select the number of minutes you want for the printer to wait before it enters Sleep mode.

3Touch .

Using Hibernate mode

Hibernate is an ultra‑low‑power operating mode. When operating in Hibernate mode, the printer is essentially off, and all other systems and devices are powered down safely.

Notes:

•Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long press of the Sleep button will wake the printer from Hibernate mode.

•Hibernate mode can be scheduled. For more information, see “Using Schedule Power Modes” on page 108.

•If the printer is in Hibernate mode, then the Embedded Web Server is disabled.

Using the Embedded Web Server

1Open a Web browser, and then type the printer IP address in the address field.

Notes:

•View the printer IP address on the printer home screen. The IP address appears as four sets of numbers separated by periods, such as 123.123.123.123.

•If you are using a proxy server, then temporarily disable it to load the Web page correctly.

2Click Settings > General Settings > Sleep Button Settings.