Lexmark 35ST301, 35S0450, 35S0300, 35S0400, 35ST300, MS510DN, MS610DN manual Windows

Using MS610de 99

In Windows 8

From the Search charm, type run and then navigate to:

Apps list > Run > type devmgmt.msc > OK

In Windows 7 or earlier

1Click , or click Start and then click Run.

2In the Start Search or Run dialog, type devmgmt.msc.

3Press Enter or click OK.

bDouble‑click Ports (COM & LPT) to expand the list of available ports.

cDo either of the following:

•Press and hold the COM port where you attached the serial cable to your computer (example: COM1).

•Right‑click the COM port where you attached the serial cable to your computer (example: COM1).

dFrom the menu that appears, select Properties.

eOn the Port Settings tab, set the serial parameters to the same serial parameters set in the printer. Check the serial heading of the menu settings page for the printer settings.

fClick OK, and then close all the dialogs.

gPrint a test page to verify printer installation.

Changing port settings after installing a new network Internal Solutions Port

When a new Lexmark Internal Solutions Port (ISP) is installed in the printer, the printer configurations on computers that access the printer must be updated since the printer will be assigned a new IP address. All computers that access the printer must be updated with this new IP address.

Notes:

•If the printer has a static IP address, then you do not need to make any changes to the computer configurations.

•If the computers are configured to use the network name, instead of an IP address, then you do not need to make any changes to your computer configurations.

•If you are adding a wireless ISP to a printer previously configured for an Ethernet connection, then make sure the printer is disconnected from the Ethernet network when you configure the printer to operate wirelessly. If the printer is connected to the Ethernet network, then the wireless configuration completes, but the wireless ISP is inactive. To activate the wireless ISP, disconnect the printer from the Ethernet network, turn off the printer, and then turn it back on.

•Only one network connection is active at a time. To switch between Ethernet and wireless connection types, turn off the printer, connect the cable (to switch to an Ethernet connection) or disconnect the cable (to switch to a wireless connection), and then turn the printer back on.

For Windows users

1Open a Web browser, and then type the printer IP address in the address field.

Notes:

•View the printer IP address on the printer control panel. The IP address appears as four sets of numbers separated by periods, such as 123.123.123.123.