2 SYSTEM CONFIGURATION FOR SINGLE CPU SYSTEM
| 2 SYSTEM CONFIGURATION FOR SINGLE CPU SYSTEM |
| This section describes the system configuration of the High Performance model |
| QCPU, cautions on use of the system, and configured equipment. |
| 2.1 System Configuration |
2 | The outline of the equipment configuration, configuration with peripheral devices, and |
| system configuration in the High Performance model QCPU system is described below. |
(1) Equipment configuration
(a) If the main base unit (Q3B) is used
MITSUBISHI
Memory card 1
Extension of the AnS Series module 2
QA1S6 extension base unit
(QA1S65B,QA1S68B)
Power supply module ,
I/O module , Intelligent function
module of the AnS Series
High Performance model QCPU (Q02CPU,Q02HCPU,Q06HCPU, Q12HCPU,Q25HCPU)
Main base unit
(Q33B, Q35B,Q38B,Q312B)
Extension cable
(QC05B,QC06B,QC12B, QC30B, QC50B,QC100B)
MITSUBISHI
LITHIUM BATTERY
Battery
(Q6BAT)
Power supply module ,
I/O module , Intelligent function
module of the Q Series
Extension of the Q Series module
Q5B extension base unit
(Q52B, Q55B)
Q6B extension base unit (Q63B, Q65B,Q68B,Q612B)
Power supply module3 4, I/O module , Intelligent function module of the Q Series
POINTS
1: The number of memory cards to be installed is one sheet.
The memory card must be selected from SRAM card, Flash card, and ATA card according to the application and capacity.
With commercial memory cards, the Operation is not assured.
2: QA1S65B and QA1S68B extension base units are used for the power supply module, I/O module, and special function module of the AnS series.
3: The Q series power supply module is not required for the Q5B type extension base unit.
4: Q61SP cannot be used for the power supply module.
Use
2 - 1 | 2 - 1 |