Motorola MC68HC908MR16, MC68HC908MR32 - page 286

Advance Information MC68HC908MR16/MC68HC908MR32 — Rev. 4.0
286 Serial Communications Interface Module (SCI) MOTOROLA
Serial Communications Interface Module (SCI)
14.4.3.2 Character Reception
During an SCI reception, the receive shift register shifts characters in
from the PTF4/RxD pin. The SCI data register (SCDR) is the read-only
buffer between the internal data bus and the receive shift register.
After a complete character shifts into the receive shift register, the data
portion of the character transfers to the SCDR. The SCI receiver full bit,
SCRF, in SCI status register 1 (SCS1) becomes set, indicating that the
received byte can be read. If the SCI receive interrupt enable bit, SCRIE,
in SCC2 is also set, the SCRF bit generates a receiver CPU interrupt
request.
14.4.3.3 Data Sampling
The receiver samples the PTF4/RxD pin at the RT clock rate. The RT
clock is an internal signal with a frequency 16 times the baud rate. To
adjust for baud rate mismatch, the RT clock is resynchronized at these
times (see Figure 14-6):
• After every start bit
• After the receiver detects a data bit change from logic 1 to log ic 0
(after the majority of data bit samples at RT8, RT9, and RT10
return a valid logic 1 and the majority of the next RT8, RT9, and
RT10 samples return a valid logic 0)
Figure 14-6. Receiver Data Sampling
RT CLOCK
RESET
RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT1 RT2 RT3 RT4 RT5 RT8 RT7 RT6
RT11 RT10
RT9
RT15 RT14 RT13 RT12 RT16
RT1 RT2 RT3 RT4
START BIT
QUALIFICATION START BIT VERIFICATION DATA SAMPLING
SAMPLES
RT
CLOCK
RT CLOCK
STATE
START BIT LSB
PTF4/RxD