Motorola WS5100 manual Select the Configuration tab

Switch Services 5-17

2. Select the Configuration tab.

3.An ACL Id must be created before it is selectable from any of the drop-down menus. Refer to the Access Group field to define the following:

Full Access Supply a numeric ACL ID to enable the supplied ACL ID full access.

Only Control Queries Supply a numeric ACL ID to enable the supplied ID only control query access to SNTP resources.

Server and Query Enter a numeric ACL ID to enable the supplied ACL ID Server and Query access to SNTP

Accessresources.

Only Server Access Define a numeric ACL ID to enable the supplied ACL ID only server access to SNTP resources.

4. Refer to the Other Settings field to define the following:

Authenticate Time	Select this checkbox to ensure a credential authentication step is included between the
Sources	SNTP server and the switch. When this checkbox is selected, the Apply and Revert buttons
	become enabled to save or cancel settings within the Other Settings field.
Act As NTP Master	When this checkbox is selected, the Apply and Revert buttons become enabled to save or
Clock	cancel settings within the Other Settings field.
Clock Stratum	Define how many hops (from 1 to 15) the switch is from a SNTP time source. The switch
	automatically chooses the SNTP resource with the lowest stratum number. The SNTP
	supported switch is careful to avoid synchronizing to a server that may not be accurate. Thus,
	the SNTP enabled switch never synchronizes to a machine not synchronized itself. The SNTP
	enabled switch compares the time reported by several sources, and does not synchronize to
	a time source whose time is significantly different than others, even if its stratum is lower.
Listen to NTP	Select this checkbox to allow the switch to listed over the network for SNTP broadcast
Broadcasts	traffic. Once enabled, the switch and the SNTP broadcast server must be on the same
	network.