Switch Services 5-31

2. Select the Member tab.

3. Refer to the following information within the Member tab:

IP Address

Displays the IP addresses of the redundancy group member.

Status

Displays the current status of this group member. This status could have the following

 

values:

 

Configured: The member is configured on the current wireless service module.

 

Seen: Heartbeats can be exchanged between the current switch and this member.

 

Invalid: Critical redundancy configuration parameter(s) of the peer (heartbeat time,

 

 

discovery time, hold time, Redundancy ID, Redundancy Protocol version of this member)

 

 

do not match this switch’s parameters.

 

Not Seen: The member is no more seen by this switch.

 

Established: The member is fully established with this current module and licensing

 

 

information already been exchanged between this switch and the member.

 

• Unknown: No status information could be obtained.

Last Seen

Displays the time when this member was last seen by the switch.

Adoption Count

Displays the number of access ports adopted by this member.

License Count

Displays the number of licenses installed on this member.

Mode

The Redundancy Mode could be Active or Standby depending on the mode configuration on

 

the member. Refer to the Configuration screen to change the mode.

4.Select a row, and click the Details button to display additional details for this member. For more information, see Displaying Redundancy Member Details on page 5-32.

5.Select a row and click the Delete button to remove a member from the redundancy group. The redundancy group should be disabled to conduct an Add or Delete operation.

Page 201
Image 201
Motorola WS5100 manual Values, Do not match this switch’s parameters, Not Seen The member is no more seen by this switch