Motorola WS5100 manual 3.2.1.1Editing the Port Configuration

Switch Information 3-9

Name	Displays the current port name. By default, eth1 and eth2 are available.
MAC Address	Displays the port’s MAC Address. This value is read-only, set at the factory and cannot be
	modified.
Admin Status	Displays whether the port is currently Up or Down.
Speed	Displays the current speed of the data transmitted and received over the port.
Duplex	Displays the port as either half or full duplex.

3.Select a port and click the Edit button to modify the port configuration. For additional information, see Editing the Port Configuration on page 3-9.

3.2.1.1Editing the Port Configuration

To modify the port configuration:

1.Select a port from the table displayed within the Configuration screen.

2.Click the Edit button.

A Port Change Warning screen displays, stating any change to the port setting could disrupt access to the switch. Communication errors may occur even if the modification made are successful.

3.Click the OK button to continue.

Optionally select the Don’t show this message again for the rest of the session checkbox to disable this pop-up.

4.Use the Edit screen to modify the following port configurations for the selected port.