2.Click the Edit button.
The Firmware screen displays the current firmware version and whether this version is used for the next reboot.
3.Select the checkbox to use this version on the next boot of the switch.
4.To edit the secondary image, select the secondary image, click the Edit button and select the Use this firmware on next reboot checkbox.
This firmware version will now be the file initiated after the next reboot of the switch.
5.Refer to the Status field for the current state of the requests made from the applet. Requests are any “SET/GET” operation from the applet. The Status field displays error messages if something goes wrong in the transaction between the applet and the switch.
6.Click the OK button to commit the changes made and exit the screen.
3.4.2Enabling Global Settings for the Failover Image
Use the Global Settings screen to specify a firmware version for use with the failover image.
1.Select an image from the table in the Firmware screen.
2.Click the Global Settings button.
3.Select the Enable Image Failover checkbox to load an alternative firmware version if the WLAN module fails to load the selected version successfully after 2 reboot attempts.
4.Refer to the Status field for the current state of the requests made from the applet. Requests are any “SET/GET” operation from the applet. The Status field displays error messages if something goes wrong in the transaction between the applet and the switch.
5.Click OK to save and add the changes to the running configuration and close the dialog.
