Motorola WS5100 manual Following details display in the table

4-6WS5100 Series Switch System Reference Guide

3.The read-only IP Forwarding tab displays the current status between VLANs. To toggle the status of routing between VLANs, use the Enable/Disable options located at the bottom of the screen.

The following details display in the table:

Destination Subnet	Displays the mask used for destination subnet entries. The Subnet Mask is the IP mask used
	to divide internet addresses into blocks (known as subnets). A value of 255.255.255.0 will
	support 256 IP addresses.
Subnet Mask	Displays the mask used for destination subnet entries. The Subnet Mask is the IP mask used
	to divide internet addresses into blocks (known as subnets). A value of 255.255.255.0 will
	support 256 IP addresses.
Gateway Address	Displays the IP address of the Gateway used to route the packets to the specified destination
	subnet. Do not set the gateway address to any VLAN interface used by the switch.
Interface	Displays the interface name with which the destination subnet entries are attached.
Protocol	Displays the name of the routing protocol with which this route was obtained. Possible
	values are:
	•	Static — Routes are statically added by the operator.
	• DHCP — Routes obtained from the DHCP server.
	•	Connected — Routes automatically installed by the switch for directly connected
		networks based on interface IP addresses.
	•	Kernel/ ICMP — Routes added as a result of receiving an ICMP redirect from an
		intermediate router.