Chapter 6 Thumbnail Operations for
2)Enter the password set on the camera and select [OK].
ffWhen entry of the CPS password has succeeded, the message [AUTHENTICATED SUCCESSFULLY!] is displayed. ffWhen entry of the CPS password has failed, the warning message (page 197) is displayed.
@@NOTE
tt Manual authentication is valid temporarily. If the target microP2 card is removed or power is turned off, the CPS password set manually is disabled. tt Visit the following website for conditions where manual authentication is valid.
tt The encrypted microP2 memory card is not recognized on the SD card slot in a computer.
tt If the card is unable to be recognized, authenticate with the correct password, or format the card and use it as recording media, or remove it from the camera. Do not perform any operation other than manual authentication and formatting with the failed card inserted.
SD memory card status display
The status display enables confirmation of the SD memory card format condition, available memory space, etc.
Select [SD CARD] in the main menu → [CLIP] → [PROPERTY]. The same information can be displayed in the main menu → [FILE] → [SD CARD PROPERTY].
[SD STANDARD] | Indicates whether an SD memory card is formatted according to the SD/SDHC/SDXC standard. |
| ff[SUPPORTED]: Complies with SD/SDHC/SDXC standards |
| ff[NOT SUPPORTED]: Does not comply with SD/SDHC/SDXC standards |
[USED] | Used capacity (bytes) |
[BLANK] | Available space (bytes) |
[TOTAL] | Total capacity (bytes) |
[PROXY REM] | Remaining capacity for proxy recording |
[NUMBER OF CLIPS] | The number of clips on an SD memory card when clips have been copied to an SD memory card |
[PROTECT] |
Connecting to external devices using the <USB3.0> terminal (host) (USB storage mode)
You can use an HDD or SSD that can be connected via USB 2.0/USB 3.0. However, there are certain storage devices that cannot be used depending on the device.
Storage device types and available functions
The available functions differ depending on the storage device you will use. The storage device type is displayed after [PARTITION] on the left side of the storage device explorer screen.
For details, refer to “Storage device information display (explorer screen)” (page 126).
rr Storage device type
Storage device type | Features | |
[TYPE S] | A special format to enable fast read/write by card. | |
[P2STORE] | Indicates P2 STORE (AJ‑PCS060G). Writing is disabled. | |
[FAT] | Storage devices where the primary partition is FAT16 or FAT32. The partition root or CONTENTS folder | |
under any folders* is the target. | ||
| ||
[OTHER] | Indicates other storage devices other than the above. File systems other than FAT16 and FAT32, such as | |
NTFS. | ||
|
* The hierarchy of folders is down to the 3rd level and the maximum number of folders is 100. Long file names and file names with
/CONTENTS | Can be displayed. |
/SAMPLE/CONTENTS | Can be displayed. |
/SAMPLE/20090101/CONTENTS | Can be displayed. |
/SAMPLE/20090101/1200/CONTENTS | Cannot be displayed. (Cannot be displayed since this is a 4th level folder) |