Chapter 4 Adjustments and Settings for Recording — Handling setting data

4Adjust the lens aperture so that the white window in the center of the grayscale chart is about 80%.

5Press the <AUTO W/B BAL> switch towards <AWB>. White balance is automatically adjusted.

6 Measure the signal level of RGB in the waveform monitor.

7Replace the lens with the one to be used for creating the lens file.

8Fine-adjust the lens aperture so that the signal level of Gch becomes the same as the signal level obtained in step 6.

9Set [ON] in the main menu → [MAINTENANCE] → [LENS FILE ADJ] → [LENS FILE ADJ MODE].

10 Adjust so that the signal level of Rch becomes the same as Gch in the main menu → [MAINTENANCE] → [LENS FILE ADJ] →

[LENS R GAIN OFFSET].

11 Likewise, adjust [LENS B GAIN OFFSET] so that the signal level of Bch becomes the same as Gch.

Writing lens files to internal memory

1Select [SAVE] in the main menu → [FILE] → [LENS FILE], and press the jog dial button (or <SET> button). The list of lens files currently saved in camera memory is displayed.

2 Select the file to write from the list.

The title entry screen and keyboard are displayed.

3Enter the desired characters with the keyboard.

4Use the jog dial button (or cursor buttons `/{/Y/I) to select [OK], and press the jog dial button (or <SET> button). The confirmation screen is displayed.

5Select [YES], and press the jog dial button (or <SET> button). The file is saved and the file list is updated.

Reading lens files from internal memory

1Select [LOAD] in the main menu → [FILE] → [LENS FILE], and press the jog dial button (or <SET> button). The list of lens files currently saved in camera memory is displayed.

2 Select the file name to read, and press the jog dial button (or <SET> button).

The confirmation screen is displayed.

3Select [YES], and press the jog dial button (or <SET> button). Loading of the file begins.

4When the completion message is displayed, press the jog dial button (or <SET> button).

– 90 –