Chapter 3 Recording and
c:<OUTPUT>/<AUTO KNEE> switch
Set this switch to <CAM>/<ON>.
d:<TCG> switch
Set this switch to <F‑RUN> or <R‑RUN>.
e:<AUDIO SELECT CH1/3>, <AUDIO SELECT CH2/4> switches
Set these switches to <AUTO>.
@@NOTE
tt The [SLOT SEL] function is assigned to the <USER MAIN> button in the factory setting. You can switch to the P2 card to be recorded from two or more inserted P2 cards.
When the P2 to record to is switched, the number of the card slot in which the P2 card to be recorded to is inserted is displayed on the P2 remaining card capacity indicator in the viewfinder. (For details on indications in the viewfinder, refer to “Configuration of status display on viewfinder screen” (page 70).)
tt The [SLOT SEL] is enabled also during recording. The [SLOT SEL] indicator flashes in the viewfinder until switching of the P2 card to be recorded to is completed. If the card could not be switched immediately after recording is started or immediately after the P2 card is switched, [SLOT SEL INVALID] will be displayed.
tt Switch the recording media between P2 memory cards (slots 1, 2) and microP2 memory cards (slots 3, 4) from the main menu → [REC/PB] → [REC/ PB SETUP] → [REC MEDIA]. [REC MEDIA] can also be assigned to the <USER> button.
For shootingWhite/black balance adjustment to completion of recording
For shooting, use the following steps.
a
b c d e
a:<CC FILTER>/<ND FILTER> dial
b:<REC> button
c:<SHUTTER> switch
d:<AUTO W/B BAL> switch
e:<WHITE BAL> switch
1Select the <CC FILTER>/<ND FILTER> dial setting according to the light conditions.
For details on setting example of the <CC FILTER>/<ND FILTER> dial, refer to “Shooting and recording/playback functions section” (page 20).
2 Operate the <WHITE BAL> switch.
rr When white balance is already saved in memory
ffSet the <WHITE BAL> switch to <A> or <B>.
rr When neither white or black balance is saved in memory and you have no time to adjust the white balance:
ffSet the <WHITE BAL> switch to <PRST>. The white balance matched to the filter is automatically adjusted according to the <CC FILTER>/<ND FILTER> dial setting position.
rr To adjust the white balance on the spot:
ffSelect the filter matched to the lighting conditions. Set the <WHITE BAL> switch to <A> or <B>, shoot a white test subject, and follow the steps below to adjust the white balance.
1)Press the <AUTO W/B BAL> switch towards the <AWB> side to adjust the white balance. (page 49)
2)Press the <AUTO W/B BAL> switch towards the <ABB> side to adjust the black balance. (page 51)
3)Press the <AUTO W/B BAL> switch towards the <AWB> side to adjust the white balance.
3Point the camera at your subject and adjust the focus and zoom.
4When using the electronic shutter, set the shutter speed and shutter mode. (page 53)