10. Multi-unit Operation
76
6Wait until “Enter Base PIN” is displayed,
then enter “0000” (default base unit PIN),
then press {j/OK}.
LIf you changed the PIN, enter it (page 73).
LWhen the cordless handset has been
registered successfully, w will stop
flashing. If key tones are turned ON (page
71), a confirmation tone will be heard.
10.2.1 Selecting a base unit
When “Auto” is selected, the cordless handset
will automatically use any available base unit it is
registered to. When a specific base unit is
selected, the cordless handset will make and
receive calls using that base unit only. If the
cordless handset is out of range of that base
unit, no calls can be made or received.
1Press {j/OK}.
2Select “Handset Setup”, then press {>}.
3Select “Select Base”, then press {>}.
4Select the desired base unit number, or
“Auto”, then press {>}.
LThe cordless handset starts searching for
the base unit.
10.2.2 Cancelling a cordless handset
A cordless handset can cancel its own
registration (or the registration of another
cordless handset) that is stored in the base unit.
This will allow the base unit to forget the cordless
handset.
1Press {j/OK}.
2Select “Base Unit Setup”, then press
{>}.
3Enter “0000” (default base unit PIN).
LIf you changed the PIN, enter it (page 73).
4Enter “335”.
5Select “Cancel Handset”, then press
{>}.
LThe numbers of all cordless handsets
registered to the base unit are displayed.
6Select the cordless handset(s) you want to
cancel, by pressing the desired cordless
handset number.
LThe selected cordless handset
number(s) will flash.
LTo cancel a selected cordless handset
number, press the number again. The
number will stop flashing.
7Press {j/OK}.
8Select “Yes”, then press {>}.
10.2.3 Cancelling a base unit
A cordless handset can cancel a base unit that it
is registered to. This allows the cordless handset
to forget the base unit.
1Press {j/OK}.
2Select “Handset Setup”, then press {>}.
3Select “Registration”, then press {>}.
4Enter “335”.
5Select “Cancel Base”, then press {>}.
6Enter “0000” (default cordless handset
PIN).
LIf you changed the PIN, enter it (page 71).
7Select the base unit(s) you want to cancel, by
pressing the desired base unit number.
LThe selected base unit number(s) will
flash.
LTo cancel a selected base unit number,
press the number again. The number will
stop flashing.
8Press {j/OK}.
9Select “Yes”, then press {>}.
10 Press {ih}.
Note:
LTo register the cordless handset to another
base unit or to the same base unit again, see
page 75.
10.2.4 Increasing the range of the base unit
You can increase the range of the base unit by
using a DECT repeater. Please use only
Panasonic DECT repeater. See page 5 for
accessory information.
Important:
LBefore registering the repeater to this
base unit, you must turn the repeater
mode ON.

Setting the repeater mode

1. Press {j/OK}.
2. Select “Base Unit Setup”, then press
{>}.
3. Enter “0000” (default base unit PIN).
LIf you changed the PIN, enter it (page 73).
4. Select “Other Options”, then press {>}.
FC962HK-PFQX2283ZA-en.book Page 76 Thursday, September 15, 2005 4:20 PM