RIO Remote I/O System User Guide
Installing Remote Terminal Adaptors (RTAs)
Page 166
Chapter 2 Installing hardware and software
2. Connect a the po wer lead into the socket at the rear of the RTA unit, turn on the supply
and finally turn on the power switch at the rear of the unit.
The RTA16 unit will now boot up, then commence normal operation.
The LEDs on the unit will display different colours depending o n the RTA state as shown
in the next table.
Hold down button on
side of bracket and
pull out to release
link cables
Link retention
bracket
Port LED for ports 9 to 16
(shows ports open)
Configuration LED (shows RTA
has been configured by host)
Run LED (shows RTA has
booted up successfully and
is running)
Link status LEDs
Port LED for ports 1 to 8
(shows ports open) Power LED