RIO Remote I/O System User Guide
SCO UnixWare troubleshooting
Page 295
Performing the send data to port test
To run the Send data to port test proceed as follows;
1. In the tty menu, click on Port diagnostics and press the Enter key.
The Online Diagnostics menu is now displayed as show n in the next picture.
2. In the Online Dia gnostics menu, click on Send data to port.
A test parameters window is now displayed which allows to set the values required for the
duration of the test.
3. In the test parameters wind ow, use the cursor keys to select the value you want to set
then cycle through to the value you want using the space bar k ey.
Note
Before you can perform this test, you need to select the RTA and port you want using
the procedures given in Selecting the RTA and port to test on page 292.