RIO Remote I/O System User Guide
Solaris troubleshooting
Page 276
Troubleshooting guide
This section includes the following;
•Host cards on page 276
•Remote Terminal Adaptors (RTAs)on page 277
•Ports on page 278.

Host cards

Problem Action required
Device driver does not start after installation 1. Ensure PCI host cards have been installed.
See page 156.
2. Ensure ISA c ard settings have been specified.
See page 158.
Host card not recognised by system 1. Check physical installation of PCI and ISA
host cards, and ensure board correctly seated
in bus slot. See page 156 a nd page 158.
2. Check ISA board memory settings, and
ensure they match the setting specified by the
rioisacfg file during installation. See page
158.
3. Check the interrupt se tting on ISA host cards,
to see if the interrupt specified by the
rioisacfg file during installation is available for
ISA use. See page 41 .
Note that on most systems it is a
requirement that ISA interrupts are
reserved in either the BIOS setup, or
system configuration program.