RIO Remote I/O System User Guide
SCO UnixWare troubleshooting
Page 296
4. Once you have set all the test parameters you require, press the Enter key to start the
test.
The test now runs and displays the test results window shown in the next p icture on
completion.
5. Once you have finished viewing the results of your test press the Enter key to return to
the Online Diagnostics menu.
6. Press the Esc ke y to return to the main RIO configuration utility window (page 292) and
then press the Esc key again to exit the utility.
7. If you have finished run ning port diagnostics you now need to re-enable the port you have
tested.To do this, at the command prompt, type /etc/spxadmport enable r00x
(when r00x is the port number for example, r001) and press the Enter key.
For more information about spxadmport, see spxadmport utility for configuring ports on
page 240 in Chapter 4 Quick Reference.
Hint
If required, you can halt the test by pressing the Enter key.