Interfaces, 124 | Proxim AP-700 guide

Monitoring

AP-700 User Guide

Interfaces

Interfaces

This tab displays statistics for the Ethernet and wireless interfaces.

Figure 5-8 Interface Monitoring Tab (Ethernet)

Description of Interface Statistics

The following statistics are displayed for the Ethernet interface only, the wireless interface only, or for both the Ethernet and wireless interfaces:

•Admin Status (Ethernet/Wireless): The desired state of the interface: Up (ready to pass packets), Down (not ready to pass packets, or Testing (testing and unable to pass packets).

•Alignment Error (Ethernet): The number of frames received that are not an integral number of octets in length and do not pass the Frame Check Sequence check.

•Carrier Sense Errors (Ethernet): The number of times that the carrier sense condition was lost or never asserted when attempting to transmit a frame. The count increments at most once per transmission attempt.

•Deferred Transmission (Ethernet): The number of frames for which the first transmission attempt is delayed because the medium is busy.This number does not include frames involved in collisions.

•Description (Ethernet/Wireless): Information about the interface (e.g., the name of the manufacturer, the product name and the version of the hardware interface).

124

Image 124

Proxim AP-700 manual Interfaces, 124

Contents

ORiNOCO AP-700 Access Point User Guide Copyright TrademarksOpenSSL License Note AP-700 User Guide Contents Contents AP-700 User Guide Management Troubleshooting CommandsMonitoring Command Line Interface CLI General Notes Ascii Character Chart C Specifications Statement of WarrantyTechnical Support Regulatory Compliance AP-700 User Guide Introduction Introduction to Wireless NetworkingDocument Conventions Guidelines for Roaming Ieee 802.11 SpecificationsIntroduction AP-700 User Guide Management and Monitoring Capabilities Command Line InterfaceHTTP/HTTPS Interface SSH Secure Shell Management Snmp ManagementSNMPv3 Secure Management Page AP-700 Hardware Description Installation and InitializationOverview Antennas Installation and Initialization AP-700 User GuideExternal Antennas LED Indicators Active Ethernet Prerequisites Installation and Initialization AP-700 User Guide Product Package System Requirements Required Materials Hardware InstallationCabling the AP-700 Mounting the AP-700 Installing the Security CoverMounting the AP-700 to a Ceiling Installing External Antennas AP-700 Mounting Plate Mounting the AP-700 to a Wall Installing the AP in a Plenum Opening the Antenna Compartment Initialization Using ScanToolScanTool Instructions Scan List Click LAN Settings Enter Network Password screen appearsLogging Select Tools Internet Options Using the Setup Wizard 11 System Status Screen 12 Setup Wizard Setup Wizard Instructions Installing the Software Install Software with Http Interface Click Commands Update AP via Http Click Commands Reboot Install Software with Tftp Server Install Updates from your Tftp Server using the CLI Related Topics System Status System Status Screen Advanced Configuration Advanced Configuration AP-700 User Guide Configure Main Screen System Dynamic DNS SupportPage IP Configuration Network DNS Client Dhcp ServerAdvanced Start IP Address End IP Address Advanced Configuration AP-700 User Guide NetworkComment optional Dhcp Relay Agent Dhcp Relay Agent Dhcp Server IP Address Table Link Integrity Target IP Address Comment optional Link Integrity Configuration Screen Sntp Simple Network Time Protocol Sntp Configuration Screen Advanced Configuration AP-700 User Guide Network Operational Mode Interfaces Advanced Configuration AP-700 User Guide Interfaces Super Mode and Turbo ModeConfiguring 802.11d Support Ieee 802.11d Support for Additional Regulatory Domains TX Power Control/Transmit Power Level Configuring TX Power Control Wireless 802.11a/b/g Radio 10 Wireless InterfacePage Dynamic Frequency Selection/Radar Detection DFS/RD Affected Countries Wireless Service Status RTS/CTS Medium Reservation Traps Generated During Wireless Service Shutdown and Resume Click on Configure Interfaces WirelessSet Blacklist Status to Enable Channel Blacklist Table 13 WDS Example Bridging WDS WDS Setup Procedure 14 WDS Configuration Ethernet 15 Adding WDS Links 16 Ethernet Sub-tab Passwords Management Services IP Access TableSecure Management Advanced Configuration AP-700 User Guide Management Snmp SettingsHttp Access Https Access Secure Socket Layer 17 Management Services Configuration Screen Configuring SSH SSH Session SetupSSH Clients Click Commands Update AP via Http or via Tftp Uploading Externally Generated Host Keys Serial Configuration Settings Radius Based Management Access Auto Configuration and the CLI Batch File Automatic Configuration AutoConfigSet up Automatic Configuration for Static IP 19 Automatic Configuration Screen Set up Automatic Configuration for Dynamic IP Hardware Configuration Reset Chrd 20 Dhcp Options Setting the Boot Server Host Name Configuring Hardware Configuration Reset Configuration Reset via Serial Port During BootupClick Configure Management Chrd Procedure to Reset Configuration via the Serial Interface Filtering Ethernet ProtocolStatic MAC Select the Filter Operation Type Advanced Configuration AP-700 User Guide Filtering Wired MAC Address 0040F41CDB6A Wireless MAC Address 00022D5194E4Wired MAC Address Wireless MAC Address 0020A6124E38 Advanced TCP/UDP PortNumber Click Add under the TCP/UDP Port Filter Table heading Editing TCP/UDP Port Filters Click Edit under the TCP/UDP Port Filter Table heading Alarms Groups Security Trap Group Trap Name Description Severity Level Operational Trap Group Trap Name Description Severity Level Trap Name Description Severity Level Flash Memory Trap Group Trap Name Description Severity Level Alarm Host Table Tftp Trap Group Trap Name Description Severity LevelImage Trap Group Trap Name Description Severity Level Sntp Trap Group Trap Name Description Severity Level Advanced Configuration AP-700 User Guide Alarms Syslog Configuring Syslog Event NotificationsEvent Priority Description Syslog Messages Syslog Message Name Priority Severity Description Advanced Configuration AP-700 User Guide Rogue Scan 25 Preventing Rogue AP Attacks Continuous Scanning Mode Background Scanning ModeMulti-Band Scanning Rogue Scan Data Collection Click Configure Alarms Rogue Scan Rogue Scan 26 Rogue Scan Screen Bridge Spanning Tree Advanced Configuration AP-700 User Guide Bridge Storm Threshold Intra BSS Configuring Interfaces for Packet ForwardingPacket Forwarding Wireless Multimedia Extensions WME/Quality of Service QoS Click Configure QoS PolicyQoS Enabling QoS and Adding QoS policies Advanced Configuration AP-700 User Guide QoS Enter the Priority Mapping Index Click Configure QoS Priority Mapping Priority Mapping Enhanced Distributed Channel Access Edca STA Edca Table and AP Edca Table 32 Edca Tables Advanced Configuration AP-700 User Guide QoS Radius Servers per Authentication Mode and per Vlan Radius Profiles Configuring Radius Profiles Radius Servers Enforcing Vlan Access Control Advanced Configuration AP-700 User Guide 35 Add Radius Server Profile 802.1x Authentication using Radius MAC Access Control Via Radius AuthenticationRadius Accounting Accounting Attributes Authentication Attributes101 102 Vlan Overview SSID/VLAN/Security103 104 Typical User Vlan Configurations Control Access to the APClick Configure SSID/VLAN/Security Mgmt Vlan Management Vlan Disable Vlan Tagging Provide Access to a Wireless Host in the Same WorkgroupSecurity Profile Advanced Configuration AP-700 User Guide SSID/VLAN/Security Authentication ProcessWi-Fi Protected Access WPA/802.11i WPA2 107 Authentication Protocol Hierarchy 108 Configuring Security Profiles Click Configure SSID/VLAN/Security Security ProfileVLANs and Security Profiles 109 Non Secure Station WEP Station802.1x Station WPA Station 111 40 Security Profile Table Add Entries 112 Wireless MAC Access113 Configuring an SSID/VLAN with Vlan Tagging Disabled 114 43 SSID/VLAN Edit Entries Screen Vlan Tagging Disabled 115 Click SSID/VLAN/Security Wireless Configuring SSID/VLANs with Vlan Tagging Enabled116 45 SSID/VLAN Edit Entries Screen Vlan Tagging Enabled 117 Broadcast Ssid and Closed System 118 Monitoring 119 Version Monitoring AP-700 User Guide IP/ARP Table Icmp Monitoring Tab Learn Table Learn Table Monitoring Tab Radius 124 Monitoring AP-700 User Guide Interfaces 125 126 Station Statistics 127 Monitoring AP-700 User Guide Station Statistics 128 Introduction to File Transfer via Tftp or Http Commands129 Image Error Checking During File Transfer Tftp File Transfer GuidelinesHttp File Transfer Guidelines 130 Update AP Update AP via TftpCommands AP-700 User Guide 131 Commands AP-700 User Guide Update AP via Http Update AP via Http132 Commands AP-700 User Guide Retrieve File Retrieve FileRetrieve File via Tftp 133 Retrieve File via Http 134 Retrieve File via Http Command Screen Reset RebootCommands AP-700 User Guide Reboot 13 Help Link Configuration Screen 137 Help Link Troubleshooting Troubleshooting ConceptsSymptoms and Solutions Connectivity Issues Basic Software Setup and Configuration Problems Client Connection Problems Vlan Operation Issues Active Ethernet AE Reset to Factory Default Procedure Recovery ProceduresForced Reload Procedure Download a New Image Using ScanTool Download ProcedurePreparing to Download the AP Image 143 Download a New Image Using the Bootloader CLI 144 Setting IP Address using Serial Port Initializing the IP Address using CLIHardware and Software Requirements Attaching the Serial Port Cable Radius Authentication Server Related ApplicationsTftp Server 146 Troubleshooting AP-700 User Guide Related Applications 147 Command Line Interface CLI General NotesPrerequisite Skills and Knowledge Notation Conventions CLI Error Messages Navigation and Special Keys Command Line Interface CLI Variations Bootloader CLICommand Line Interface CLI AP-700 User Guide 150 Operational CLI Commands CLI Command TypesExample 1. Display Command list Example 3. Display parameters for set and show Example 2. Display specific CommandsExample 3a. Display every parameter that can be changed Example 3b. Display parameters based on letter sequence Example 4. Display Prompts for Successive ParametersDone, exit, quit Download Help HistoryPasswd 154 Parameter Control Commands Show CLI CommandSearch 155 Set CLI Command Configuring Objects that Require RebootSet and show Command Examples Examples Example 1 Set the Access Point IP Address Parameter Example 4 Enable, Disable, or Delete a table entry or rowExample 2 Create a table entry or row Example 3 Modify a table entry or row Example 6 Show Individual and Table Parameters Example 5 Show the Group Parameters158 Using Tables and Strings Using StringsWorking with Tables 159 Configuring the AP using CLI commands Set Basic Configuration Parameters using CLI CommandsLog into the AP using HyperTerminal Log into the AP using Telnet Change Passwords Set Network Names for the Wireless InterfaceSet System Name, Location and Contact Information 161 Country Code 162 Configure SSIDs Network Names, VLANs, and Profiles 163 Other Network Settings Download an AP Configuration File from your Tftp ServerBackup your AP Configuration File Set up Auto Configuration Configure the AP as a Dhcp Server Configure the DNS Client Enable/Disable Closed System Operational ModeAutochannel Select ACS Shutdown/Resume Wireless Service Enable/Disable Super Mode 802.11a/g onlyEnable/Disable Turbo Mode 802.11a/g only Configure Antenna Diversity Configure Management Ports Edit Management IP Access TableSet Communication Ports Configure Secure Socket Layer Https Set Telnet Session TimeoutsConfigure Serial Port Interface 169 Create/Enable WDS Enable/Disable WDSSetup MAC Address Access Control Add an Entry to the MAC Access Control Table Figure A-17 Result of showradiustbl CLI Command 171 Disable Vlan Management Enable Vlan ManagementAdd a Entry to the Wifssid Table CLI Monitoring Parameters Parameter Tables 174 Filtering Parameters 175 Name Type Value Access CLI Parameter Set sysresettodefaultsSystem Parameters 176 DNS Client for Radius Name Resolution Dhcp Server Parameters Name Type Value Access CLI ParameterNetwork Parameters 177 Dhcp Server table for IP pools Dhcp Relay GroupDhcp Relay Server Table 178 Link Integrity IP Target Table Sntp Parameters Name Type Value Access CLI Parameter179 Wireless Interface Parameters Interface ParametersCommon Parameters to 802.11a/b/g 180 802.11a Only Parameters 181 802.11b/g Only Parameters 802.11b Only Parameters182 For 802.11g-only mode For 802.11b/g modeFor 802.11b-only Mode Wireless Distribution System WDS Parameters Wireless Interface SSID/VLAN/Profile ParametersChannel Blacklist Parameters 184 Wireless Distribution System WDS Security Table Parameters Snmp Parameters Name Type Value Access CLI ParameterManagement Parameters 185 186 Telnet Parameters Name Type Value Access CLI Parameter Http Parameters Name Type Value Access CLI Parameter187 Serial Port Parameters Name Type Value Access CLI Parameter Radius Based Management Access ParametersSSH Parameters 188 Tftp Server Parameters IP Access Table Parameters189 Ethernet Filtering Table Filtering Parameters190 Proxy ARP Parameters Name Type Value Access CLI Parameter TCP/UDP Port FilteringTCP/UDP Port Filtering Table 191 Alarms Parameters Name Type Value Access CLI Parameter Syslog Group 192Snmp Table Host Table Parameters Syslog Parameters Syslog Host Table 193 Spanning Tree Priority and Path Cost Table Bridge Parameters194 Storm Threshold Table Intra BSS Subscriber BlockingPacket Forwarding Parameters 195 Radius Server Configuration Parameters Radius ParametersGeneral Radius Parameters 196 MAC Access Control Table Security Parameters Security Profile Table VLAN/SSID Parameters198 Iapp Parameters Name Type Value Access CLI Parameter Enabling QoS Name Type Value Access CLI ParameterConfiguring QoS Policies Other Parameters Specifying the Mapping between 802.1p and 802.1D Priorities 200 CLI Batch File Defining the QoS Policy used for a Wireless Interface Ssid201 Reboot Behavior Auto Configuration and the CLI Batch FileCLI Batch File Format and Syntax CLI Batch File Error Log 203 Hex Ascii Character ChartCharact Equival Ent 204 Specifications Software FeaturesNumber of Stations per BSS Management Functions Medium Access Control MAC Functions Specifications AP-700 User Guide Software FeaturesAdvanced Bridging Functions Security Functions Network Functions Specifications AP-700 User Guide207 Hardware Specifications Mode Frequency Channel Product SKU Band Available Channels802.11b/g 802.11a Upper 149 153 157 161 ISM Band 165 802.11a RF Performance 802.11a Data Rates Mbps RF Performance210 Online Support Technical SupportSoftware and Documentation Downloads Knowledgebase 211 Technical Support AP-700 User Guide Telephone Support Telephone SupportInternational 212 Statement of Warranty Warranty CoverageRepair or Replacement Limitations of Warranty Ask a Question or Open an Issue Other InformationSearch Knowledgebase Other Adapter Cards Product Model Numbers Regulatory Compliance215 Regulatory Compliance AP-700 User Guide Safety Information USA, Canada, & European Union216 Federal Communications Commission FCC 217 Modifications 218 Industry Canada IC 219 European Union 220 Country Certification/Reference No Regulatory Compliance Certifications Summary221