Command Line Interface (CLI) |
|
Parameter Tables |
|
|
|
•statiapp: Displays the IAPP statistics.
•statradius: Displays the RADIUS Authentication statistics.
•statif: Displays information and statistics about the Ethernet and wireless interfaces.
•stat802.11: Displays additional statistics for the wireless interfaces.
•statethernet: Displays additional statistics for the Ethernet interface.
•statmss: Displays station statistics and Wireless Distribution System links.
Parameter Tables
Objects contain groups that contain both parameters and parameter tables. Use the following Tables to configure the Access Point. Columns used on the tables include:
•Name - Parameter, Group, or Table Name
•Type - Data type
•Value - Value range, and default value, if any
•Access = access type, R = Read Only (show), RW =
•CLI Parameter - Parameter name as used in the Access Point
Access Point network objects are associated with Groups. The network objects are listed below and associated parameters are described in the following Parameter Tables:
•System Parameters - Access Point system information
–Inventory Management Information - Hardware, firmware, and software version information
•Network Parameters - IP and Network Settings
–IP Configuration Parameters - Configure the Access Point’s IP settings
— DNS Client for RADIUS Name Resolution - Configure the Access Point as a DNS client
–DHCP Server Parameters - Enable or disable dynamic host configuration
–SNTP Parameters - Configure
–Link Integrity Parameters - Monitor link status
•Interface Parameters - Configure Wireless and Ethernet settings
–Wireless Interface Parameters
—Channel Blacklist Parameters - View and configure blacklisted channels
—Wireless Distribution System (WDS) Parameters - Configure the WDS partnerships
–Wireless Interface SSID/VLAN/Profile Parameters - Configure the SSIDs, VLANs, and security modes. Up to 16 SSIDs are supported; different security settings can be applied to each SSID, and a unique VLAN can be configured per SSID.
–Ethernet Interface Parameters - Set the speed and duplex of the Ethernet port.
•Management Parameters - Control access to the AP’s management interfaces
–SNMP Parameters - Set read and read/write passwords
–HTTP Parameters - Set up the graphical web browser interface. If required, enable SSL and configure the SSL certificate passphrase.
–Telnet Parameters - Telnet Port setup
–Serial Port Parameters - Serial Port setup
–RADIUS Based Management Access Parameters - Configure RADIUS Based Management Access for HTTP and Telnet access.
–SSH Parameters - Enable SSH and configure the host key.
–TFTP Server Parameters - Set up for file transfers; specify IP Address, file name, and file type
