Command Line Interface (CLI) |
|
Parameter Tables |
|
|
|
–IP Access Table Parameters - Configure range of IP addresses that can access the AP
–Auto Configuration Parameters - Configure the Auto Configuration feature which allows an AP to be automatically configured by downloading a configuration file from a TFTP server during boot up.
•Filtering Parameters
–Ethernet Protocol Filtering Parameters - Control network traffic based on protocol type
–Static MAC Address Filter Table - Enable and disable specific addresses
–Proxy ARP Parameters - Enable or disable proxy ARP for wireless clients
–IP ARP Filtering Parameters - Control which ARP messages are sent to wireless clients based on IP settings
–Broadcast Filtering Table - Control the type of broadcast packets forwarded to the wireless network
–TCP/UDP Port Filtering - Filter IP packets based on TCP/UDP port
•Alarms Parameters
–SNMP Table Host Table Parameters - Enter the list of IP addresses that will receive alarms from the AP
–Syslog Parameters - Configure the AP to send Syslog information to network servers
•Bridge Parameters
–Spanning Tree Parameters - Used to help prevent network loops
–Storm Threshold Parameters - Set threshold for number of broadcast packets
–Intra BSS Subscriber Blocking - Enable or disable peer to peer traffic on the same AP
–Packet Forwarding Parameters - Redirect traffic from wireless clients to a specified MAC address
•RADIUS Parameters
–Set RADIUS Parameters - Configure RADIUS Servers and assign them to VLANs.
•Security Parameters - Access Point security settings
–MAC Access Control Parameters - Control wireless access based on MAC address
–Rogue Scan Configuration Table - Enable and configure Rogue Scan to detect Rogue APs and clients.
–Hardware Configuration Reset - Disable or enable hardware configuration reset and configure a configuration reset password.
–VLAN/SSID Parameters - Enable the configuration of multiple subnetworks based on VLAN ID and SSID pairs.
–Security Profile Table - Configure Security Profiles that define allowed security modes (wireless clients), and encryption and authentication mechanisms.
•Other Parameters
–IAPP Parameters - Enable or disable the
–Wireless Multimedia Enhancements (WME)/Quality of Service (QoS) parameters - Enable and configure Wireless Multimedia Enhancement/Quality of Service parameters, QoS policies, mapping priorities, and EDCA parameters. Apply a configured QoS policy to a particular SSID.
