Ricoh Network Guide ❖Display, msh> snmp, msh> snmp, View settings, msh> smb group, ❖View settings, ❖Deleting Comment, ❖Protocol settings, ❖Deleting Group Name

Monitoring and Configuring the Printer

smb

Use the “smb” command to configure or delete the computer or workgroup name for SMB.

snmp

Use the “snmp” command to display and edit SNMP configuration settings such as the community name.

❖Computer Name settings msh> smb comp

•Set computer name using up to 15 characters. Names beginning with "RNP" or "rnp" cannot be entered.

4	❖ Working Group Name settings
	msh> smb group

•Set workgroup name using up to 15 characters

❖Comment settings msh> smb comment

•Set comment using up to 31 characters

❖Notify print job completionmsh> smb notif {on off}

•To notify print job completion, specify “on”. Otherwise, specify “off”

❖Deleting Computer Name msh> smb clear comp

❖Deleting Group Namemsh> smb clear group❖Deleting Commentmsh> smb clear comment❖Protocol settingsmsh> smb protocol [netbeui {up down} tcpip {up down}]

•Enable or disable NetBEUI and TCP/IP. Specify “up” to enable, and “down” to disable.

102

❖View settings

msh> snmp

•Default access settings 1 is as follows:

Community name:public IP address:0.0.0.0

Access type:read-only / trap off

•Default access settings 2 is as follows:

Community name:admin IP address:0.0.0.0

Access type:read-write / trap off

•If "-p" is added, you can view settings one by one.

•To display the current commu- nity, specify its registration number.

❖Displaymsh> snmp ?❖Community name configurationmsh> snmp “number” name “community_name”

•You can configure ten SNMP access settings numbered 1-10.

•The printer cannot be accessed from SmartDeviceMonitor for Admin or SmartDeviceMonitor for Client if “public” is not reg- istered in numbers 1-10. When changing the community name, use SmartDeviceMonitor for Admin and SNMP Setup Tool to correspond with printer set- tings.

•The community name can be entered using up to 15 charac- ters.