Samsung DVR-8TH, DVR-4TH Load Factory Default, Import Configuration, Export Configuration

User’s Manual

5.8.1Load Factory Default

This item is used to load the factory default setting. Select <Yes> to recall the factory default setup configuration from the “read-only” memory, or select <No> to cancel.

5.8.2Import Configuration

This item allows the user to load a unit configuration that was saved on an external drive. To import a configuration that was previously exported, make sure the device that saved the configuration is connected to the unit. Select <Import Config> from the Configuration menu and press ENTER. The following menu is displayed.

	Import Config
Config Name	Select
xxxx-xxxx	No
xxx-xx	No

Press UP / DOWN to select one of the available listed configuration files, and choose <Yes> to start importing.

NOTE: If the imported configuration has a different record mode from the unit’s, the warning message “This config has different record mode. This will FORMAT ALL HARDDISKS.” will show.

NOTE: Remove the ThumbDrive® used for importing configuration after the unit restarts, or it will be formatted as well.

5.8.3Export Configuration

The account with appropriate privilege can save a unit configuration by exporting it to an external drive, such as a USB Flash Drive. Before exporting the configuration, make sure the device in which the configuration will be saved is attached to the unit properly. Select <Export Config> from the Configuration menu and press ENTER. The following menu is displayed. Items in this menu are described in the following sections.

	Export Config
Copy Destination
Config Name
Begin Export	No

118	DVR-4TH/8TH/16TH Series
	SPECO TECHNOLOGIES 07/10