Savin 2045 appendix Placing Originals, Specifying Original Orientation and Setting Originals

3. Setting Originals

This chapter explains the procedure for placing originals on the exposure glass and in the ADF, and setting the original scan area and orientation according to the placement method.

To correctly display the top/bottom orientation of the scanned original on a computer, the placement of the original and the settings made on the control panel and scanner driver must match.

Placing Originals

There are two orientations for placing the original. See the table below.

Note

❒Normally, an original is or , but in the table below, a square original is used to make original orientation easy to understand. If the actual shape of the original is different, the combination of original orientation and the orien- tation specified on the control panel or scanner driver does not change.

❖Specifying Original Orientation and Setting Originals

An original to be scanned
	Exposure glass		ADF
Decide the placement method.
	Place the	Place the	Place the top	Place the
Place the original.	original so	original so	edge of the	original so
	that the top	that the top	original first.	that the top
(There are two original orien-	edge touches	edge touches		edge touches
tations.)	the top left of	the rear of		the back of
	the expo-	the exposure		the ADF.
	sure glass.	glass.

31